Stop clothing rustle before the interview starts

Begin with a mount you can inspect

A lavalier can sound clean while someone sits perfectly still and become unusable when they turn toward an interviewer. Make the rehearsal resemble the recording. Ask the speaker to settle into the actual chair, turn both ways, gesture and lean forward before you approve the setup. This guide offers a recommended preparation routine; it does not report a test of a particular wardrobe or microphone.

RØDE's mounting guidance describes a small cable loop at the clip and additional strain relief below it to reduce movement noise. Use that as a starting point, then listen to your own placement. If a visible capsule is acceptable, begin there: you can see whether a collar, necklace or jacket edge touches the microphone as the speaker moves.

Find which contact creates the noise

Record a short spoken sentence followed by the planned gestures. Play it back through headphones. Then ask the speaker to remain still while you gently move one accessible section of cable. Next, leave the cable alone and move the surrounding fabric. Change one thing at a time so you can identify a useful fix instead of collecting several uncertain ones.

If fabric reaches the capsule, try a different edge of clothing or adjust the route before hiding the microphone more deeply. If a cable tug causes the noise, leave comfortable slack near the microphone and secure the lower run so the transmitter does not pull on it. Keep enough freedom for normal movement; a taut installation that only works in one pose is not ready for an interview.

Treat a hidden mount as a new setup

Concealment adds another variable. Plan a small protected space around the capsule, and check it while the person is seated as well as standing. Use mounting materials intended for the contact surface and obtain the speaker's agreement before attaching anything to clothing or skin. A visible, reliable placement may be the better production decision when time is short.

With the RØDE Wireless PRO, the manufacturer documents threaded transmitter inputs that secure a compatible locking lavalier plug. A secured connector addresses accidental unplugging; it does not certify that the capsule or cable is quiet. Check both the connection and the mount rather than treating them as one problem.

• Remove or reposition a necklace, zipper pull or lanyard that touches the mount, with permission.
• Rehearse the widest likely gesture and check for a cable tug.
• Check the shot and listen to the recorded result before starting the full take.

Make the pass repeatable

Once the setup works, note the mounting edge and cable route in the session log. Repeat the short check after a jacket comes off, a chair moves or the transmitter changes pockets. Keep the original recording even if you later apply cleanup. If a passage contains intrusive rustle, pause and repeat the sentence while the speaker and context are still available. That gives the editor a clean choice without assuming software can reconstruct every obscured word.